D-Link UNIFIED WIRED & WIRELESS ACCESS SYSTEM DWS-3000 - Manual (Page 24)

24 © 2001- 2008 D-Link Corporation. All Rights Reserved.
Wired Configuration Guide
Quick Start up IP Address
To view the network parameters the operator can access the device by the following three
methods.
• Simple Network Management Protocol - SNMP
• Telnet
•
Web Browser
NOTE: Helpful Hint: The user should do a ‘copy system:running-config nvram:star-
tup-config’ after configuring the network parameters so that the configura-
tions are not lost
Table 4. Quick Start up IP Address
Command Details
show network
(User EXEC Mode)
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 10.90.90.90
Subnet Mask - IP Subnet Mask for the interface
Default is 255.0.0.0
Default Gateway - The default Gateway for this interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC Address used for
in-band connectivity
Locally Administered MAC Address - Can be configured to allow a
locally administered MAC address
MAC Address Type - Specifies which MAC address should be used
for in-band connectivity
Network Configurations Protocol Current - Indicates which net-
work protocol is being used
Default is none
Management VLAN ID - Specifies VLAN ID
network parms
[gateway]
(Privileged EXEC Mode)
Sets the IP Address, subnet mask, and gateway of the router. The IP
Address and the gateway must be on the same subnet.
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Gateway Address range from 0.0.0.0 to 255.255.255.255