Proel PRONET v.2.1 - Manual (Page 34)

34
Routing
Shows the routing source for the output channel (see “Processor setup panel” and “Routing”).
6.2.2 Output Compressor/Limiter
Fig.48 Output limiter: parameters and visualization.
The output Compressor/Limiter is placed after the level control and before the mute control.
Limit
This parameter enables or disables the “Limiter Mode”: disabling this mode the limiter acts as a compressor
with a compression amount set by the Ratio parameter.
Thresh
Threshold level for the limiter: below the threshold no limiting occurs, above the threshold the processor
start to limit the signal. The threshold level is referred to the maximum dynamic for the Output signal, so
Thresh=+21dB means “threshold at the maximum level of output signal”.
Atk
Attack time for the limiter: determines how quickly the limiter reacts to signals above the threshold.
Rel
Release time for the limiter: determines how quickly the limiter restores its normal gain after the signal goes
below the threshold.
Ratio
Select the amount of compression for the signal. Compression ratio parameter determines the input/output