Caution danger, Warning, 1 pbc unpacking – OnLine Power PBC I User Manual
Page 23: 2 inspection, 3 pbc storage, Battery shelf life

SECTION 3 - PBC INSTALLATION
3-1 PBC Unpacking
• The unit is delivered on a pallet, secured using metal bands. On removing the PBC from the pallet, be sure to
keep the protective wrapping in place. Use the following procedure to unpack the unit.
• Position the pallet away from walls or other obstructions.
• Be sure pallet is sitting level where bands cannot hit anything.
CAUTION
DANGER
• Exercise extreme caution as you cut the metal bands. They are under tension and may cause injury.
• Carefully remove the cardboard cover from unit; avoid puncturing the plastic bubble wrap with any sharp object
that may damage the surface of unit.
• The bubbles wrap covers the PCB and should be removed at location when the unit is to be mounted.
• Save the packing material to allow it to be used to keep the unit covered and protected until start- up.
• Place units in location where it's used, then remove protective plastic film.
• Before final positioning of unit, verify that all cable routing and raceway are in the correct position.
3-2 Inspection
• Inspect the PBC for obvious damage or safety hazards that may have occurred during shipping or handling of
unit.
• Inspect all units when received and before use.
• Report any damage immediately to the originating factory, or to an authorized representative.
• Initiate Freight damage claims with the carrier soon as possible.
• Compare the contents and model numbers with the packing list to ensure that all of the items were received.
3-3 PBC Storage
• The batteries are installed before shipment of PBC for details of battery shelf time read appendix C.
• Provide a protected environment that meets the environmental limits listed below.
• Storage and Transport Temperature Range is - 40°C to +60°C
• Relative humidity: 0 % to 95 % non-condensing (inside cabinet).
WARNING!
Battery shelf life!
• Battery shelf life, when stored under temperature conditions of 66°F ~ 90°F, is five (5) months maximum after
the ship date.
• For the battery shelf life details read appendix C.
16