Factory default output messages, Factory default nct messages, Message descriptions – NavCom StarUtil-3000 Rev.A User Manual
Page 70: Table 6: factory default nct messages & responses
StarUtil-3000 User Guide – Rev A
6-68
Factory Default Output Messages
The factory default for the SF-3050 is to output 8 NCT messages via COM1 and USB1, and 3
NCT messages on all ports (see Table 6). The user has full control over the utilized message
types and their associated rates.
NMEA messages are not output by default. They must be scheduled by the user
via a user profile or the Input Terminal. Use the NMEA tab to view the scheduled
NMEA messages (see Figure 128).
Factory Default NCT Messages
Table 6: Factory Default NCT Messages & Responses
Output on Ports COM1 and USB1
Message Rate
Description
ALM1B
On Change
Satellite Almanac
CHNLSTATUS1B
On Time 1Hz
ASIC & StarFire Channel Status
EPHEM1B
On Change
Satellite Ephemeris
MEAS1B
On Time 1Hz
Raw Satellite Measurement Data
MSGPRODUCTINFO On Time 600 Sec
Product Type, Digital Serial Number, and System Revision
Number
MSGVERSION
On Time 600 Sec Firmware Identification Block
PVT1B
On Time 1Hz
Position, Velocity, and Time (PVT) Solution
PANICA
On Change
Factory Use
Output on All Ports
Message Rate
Description
OK (mnemonic)
On Change
Ack (“Acknowledged”).
Ack indicates a successful input message operation.
?? (mnemonic)
{argument error}
On Change
Nak (“Not Acknowledged”). NAK indicates a failure in
executing a command.
PANICA
On Change
Factory Use
Refer to the section above,
, for definitions of these rates.
Message Descriptions
The following message descriptions are fully defined in the Sapphire Technical Reference
Manual (see Related Documents).
ALM1B Packed Almanac:
Data corresponding to each satellite in the GPS constellation, including: GPS Week number
of collected almanac, GPS Time of week [in seconds] of collected almanac, almanac
reference week, almanac reference time, almanac source, almanac health, pages 1-25, and
sub-frames 4 and 5. Packed almanac data for 32 GPS or 24 GLONASS satellites.
CHNLSTATUS1B Channel Status:
Receiver channel status information containing: Sapphire engine status, number of satellites
viewed/tracked, PDOP, tracked satellite identity, satellite elevation and azimuth, C/No for the
track signals, and correction age for each satellite.