NavCom StarUtil-3000 Rev.A - Manual (Page 44)

StarUtil-3000 User Guide – Rev A
Figure 54: Settings For GNSS Firmware
3-42
7. Set these options:
 Baud Rate:
 Serial Connection: Refer to the section above,
PC Baud Rate Requirements for
Firmware Upload Via Serial Connection .
 USB 2.0 Device or Ethernet Connection: No selection is necessary. The speed of the
connection is automatically set.
 Target:
 Select SOLARIS to upload GNSS firmware (see Figure 54):
SP_boot1_[version number].s19
SP_boot2_[version number].s19
SPv[version number].s19
Or
 Select SOLARIS PIO to upload PWRIO firmware (see Figure 55):
SP_PWRIOboot1_[version number].s19
SP_PWRIO_[version number].s19
 Bootloader: Do not set this option. The program automatically sets the buffer type.
 Force Load Firmware Without PING: Keep the default (unchecked).
Figure 55: Settings For PWRIO Firmware
8. Click the Load button. An upload progress window opens. At the end of upload, a
confirmation box opens. Click OK.
9. Repeat the steps above to upload more firmware files if necessary.