NavCom StarUtil-3000 Rev.A - Manual (Page 63)

StarUtil-3000 User Guide – Rev A

Scrolling command mnemonics in the Communication window indicate a valid
connection. Scrolling lines designated as “DATA” indicate a broken communication
link (see Figure 75).
Figure 75: Indication of Broken Communication Link
 Perform these steps to avoid the user profile loading error explained above
 Move the [PORT] commands to the end of the user profile. In addition, move the control port
command to the bottom-most position (see Figure 76).
[OUTPUT]PANICA,ONCHANGE,,ETH2
[2DNAVMODE]AUTO,0.0000
[PDOPLIMIT]10.0
[RTKTIMEOUT]15.0
[RTKFLOATTIMEOUT]300
[RTKMODE]rover,NCT,1
[PRDGPSMODE]RTCM1,OFF
[PRDGPSMODE]WAASEGNOS,ON
[PRDGPSTIMEOUT]RTCM1,300
[PRDGPSTIMEOUT]WAASEGNOS,300
[REFSTNPOS]0,0,0.000000,0,0,0.000000,0.000000
[L1FALLBACK]OFF
[PORT]2,19200,8,1,NONE
[PORT]3,57600,8,1,NONE
[PORT]4,57600,8,1,NONE
Control Port [PORT]1,115200,8,1,NONE
Figure 76: Example User Profile – [PORT] Commands at End of User Profile
 Before uploading the user profile:
 Input a new baud rate. From the user profile, copy the command string for the control
port, for example, [PORT]1,115200,8,1,NONE.
 Paste the command string into the Input Terminal window in StarUtil-3000 (see the
example in Figure 77).
Figure 77: Input of New Baud Rate
 Click
the Send button.
 Re-establish communication between the PC and the receiver at this new baud rate.
 Upload the user profile.

Because the PC baud rate matches the receiver baud rate in the user profile, the
entire user profile loads without communication errors.
6-61