NavCom StarUtil-3000 Rev.A - Manual (Page 116)

StarUtil-3000 User Guide – Rev A
Figure 134: Data Parsing Options
Refer to Figure 134 for the options below:
 Time Start/Time End: Enter a specific time to use as the start and/or end time. Only data
appropriate to the timestamps in these fields is extracted.
 Entering only a start time leaves out the data that has an earlier timestamp.
 Entering only an end time extracts all data that has a timestamp less than the entered
value.

Entering Start/End times is useful to focus on an issue that occurred during a
specific time period.
 Write to Disk after [sec]: Enter the interval in seconds for the log file to be processed. For
example, a log file has PVT1B data at 10Hz. To extract the PVT1B data to the *.txt file at a
1Hz interval, enter 1 in the field.
 Format PVT and MEAS for Matlab: Check to extract the data in Matlab format.
Simulation
The simulation dialog box provides a simulation of receiver operation via the playing of a saved
log file (*.dat).
Figure 135: Simulation Dialog Box
1. Click the Simulation button on the Post Processing menu to open the Simulation dialog box
(see Figure 135).
2. Click to select a log file (*.dat) to play. The path to the file appears in the field.
3. The dialog box provides these controls:

Play

Stop
 Update every 300 (default) milliseconds: Refresh rate of simulation
11-114