MicroE Mercury II 6000V - Manual (Page 48)

Page 26
End Cap Installation
B9.0
Epoxy Setup
• Mix the two-part epoxy and place it in a
syringe or on the end of a stick. Do not use
a cotton swab to apply the epoxy.
• Put epoxy on the end of the scale. Make
sure that the epoxy touches both the
mounting surface and the scale across the
width of the scale.
Only apply epoxy at the ends
of the tape scale. Do not get
any epoxy on the tape scale
in the measuring area.
• Perform Step B9.1 immediately while the
epoxy is still in a liquid state.
Section B - PurePrecision ™ Tape Scale Installation