Index and limit marker installation – MicroE Mercury II 6000V User Manual
Page 46

Page 24
Index and Limit Marker Installation
PurePrecision
™
Tape Scale
B8.1
Attaching the Index Marker to
the Tape Scale
Place the top edge of the marker against the
benching edge holding it at a 45° degree angle
as shown in the photo.
If the tape scale is installed with an offset from
its reference edge, a temporary reference
surface such as a small metal block must be
used for the index and limit markers.
When the marker is tight against the reference
edge (or benching surface), press the marker
onto the tape scale with your finger.
* USE FINGER COTS
Section B - PurePrecision
™
Tape Scale Installation
This manual is related to the following products: