Index and limit marker installation – MicroE Mercury II 6000V User Manual
Page 47

Page 25
Index and Limit Marker Installation
PurePrecision
™
Tape Scale
Press your finger on the marker close to the edge
of the handle. Then, with your other hand, pull
up on the handle to detach it from the marker.
The handle will break away from the marker.
Carefully remove the blue protective film from
the marker surface.
TIP:
Use fingernails or plastic tweezers
to remove the blue protective film,
but do not use a hard metal object.
Using a hard metal object might
damage the grating on the
PurePrecision Tape Scale.
B8.2
(Applies only to Mercury
II
™
5000 and
4000 models)
Repeat steps B8.0 and B8.1 for the left and
right limit markers.
Section B - PurePrecision
™
Tape Scale Installation
* USE FINGER COTS
This manual is related to the following products: