Pureprecision, Tape scale installation – MicroE Mercury II 6000V User Manual
Page 33

Page 11
PurePrecision
™
Tape Scale Installation
By Hand
B6.1.2
Removing/peeling the adhesive liner.
Using a sharp tool or fingernails initiate the
peeling of the adhesive liner from designated
"LEFT END" of the tape scale.
Remove/peel back a short length of about
25mm (1 inch) taking care not to touch the
adhesive or allow any particulate
contamination.
NOTE:
Be careful not to expose the adhesive
liner more than 50mm (2 inches).
Do not peel the blue protective film off at
this time.
B6.1.3
Flip the tape over such that exposed adhesive
surface of the tape scale (surface from which
the adhesive liner was removed) faces the
desired location where the tape needs to
be attached.
Adhesive liner peeled off about
25mm (1 inch) from the designated
“LEFT END”
Section B - PurePrecision
™
Tape Scale Installation