Setup using software, Sensor head alignment – MicroE Mercury II 6000V User Manual
Page 11

Page 11
Sensor Head Alignment -
Mercury
II
™
6000 Models – Setup using Software
B2.4.1
Connect the Alignment Tool and Encoder
Verify that the Alignment Tool Adapter /
SmartPrecision
II
Alignment Tool is not powered.
Connect the MII 6000 encoder and Ethernet
cable as shown below. Power up the Alignment
Tool Adapter / SmartPrecision II Alignment Tool
by plugging in the power supply. The green LED
labeled “On” will light when the Alignment Tool
is powered.
B2.4.2
Find the Encoder Using FindMII.exe
Once the encoder is connected to the
computer using an Ethernet cable, run the
program FindMII.exe, version 1.2.2.1 or
higher, available by downloading from
www.microesys.com/m2/software.html
This program locates the encoder and
allows you to use the SmartPrecision II
Software embedded in it. Once located,
the FindMII program will list all the
encoders connected to the network.
DC Power Supply
Ethernet
Cable
Windows
OS
Computer
Section B - Sensor Head Installation, Alignment and Calibration
Double-click the name of the encoder to open the SmartPrecision II Software.