MicroE Mercury II 6000V User Manual
Mercury, Installation manual and reference guide
Mercury
IIII
TM
6000 & 6000V
MicroE Systems - World Headquarters: 125 Middlesex Turnpike, Bedford, MA USA 01730-1409
IM-Mercury_
II
_6000_6000V Rev D
www.microesys.com
[email protected] T. 781-266-5700
F. 781-266-5112
©2010 MicroE Systems
Installation Manual
and Reference Guide
This manual is related to the following products:
Table of contents
Document Outline
- MII6000-6000V Manual
- Cover Page
- Intro & Precautions
- System Overview
- Sensor Head Installation, Alignment and Calibration
- SmartPrecision Alignment Tool
- Pushbutton Setup Alignment
- Pushbutton, linear scales or rotary <360 degrees
- Pushbutton, rotary scales >360 degrees
- Setup using Software
- Calibration-using Software
- Alignment Verification LEDs
- Grounding Instructions
- Recommendations for Power
- Recommended Interface Termination
- Interface Cable Requirements
- Shield Termination
- Index Speed Considerations
- Troubleshooting
- Contacting MicroE Systems
- Tape Scale Installation
- Pre-Installation Info
- Tools Required for Installation
- Pre-Installation Precautions-1
- Pre-Installation Precautions-2
- Flowchart
- Design Guide
- Mounting Surface Prep
- Cutting Tape Scales
- Installation Method
- Removing Blue Film
- Index & Limit Marker Installation
- End Cap Installation
- Final Cleaning, Inspectin and Cure Time
- Reworking to Correct Mistakes
- Troubleshooting
- Glass Scale Installation