Measurement Computing CIO-DAS160x/1x - Manual (Page 34)

6.1.14 DAS1600 MODE ENABLE REGISTER
BASE ADDRESS +406h
M M M M M M M M
0 1 2 3 4 5 6 7
WRITE ONLY. DAS1600 mode enable. Writing 40 hex to this register enables the DAS1600 functions.
Writing 0 to this register disables DAS1600 functions. On power-up or reset the DAS1600 functions are
disabled.
6.1.15 BURST STATUS REGISTER
BASE ADDRESS + 407h
CLK WS 0 0 CD ME BME 0
0 1 2 3 4 5 6 7
READ ONLY. This register provides status on:
a. The clock select switch and wait state switch.
b. The DAS1600 enable, Conversion Disable and Burst Mode Enable bits.
The register defaults to 000100XX on power-up or reset, which corresponds to the programmable bit
default settings plus the state of the switches. The bit assignments are as follows.
BME 1 = Burst Mode Enabled, 0 = disabled.
ME 1 = DAS1600 Mode Enabled, 0 = disabled.
CD 1 = Conversions allowed, 0 = conversions disabled.
WS 1 = Wait State Enabled, 0 = No wait state.
CLK 1 = 10 MHz clock selected, 0 = 1 MHz clock selected.
30