Datalogic Scanning Pegaso - Manual (Page 110)

Programming Parameters
F-2 Pegaso™ Industrial PDA with Windows ® CE
Programming Codes Without Parameters
The following table describes the functions of special bar codes that take no parameters:
Table F-1. Programming Codes Without Parameters
Code
Parameter
I.D. # Function
Defaults
Minimum
FF39
Turns every On/Off parameter off and sets all minimum
and Maximum Label Lengths to the lowest values.
Defaults
Maximum
FF3A
Turns every On/Off parameter on and sets all minimum
and Maximum Label Lengths to the highest values. This
default set is normally used only for troubleshooting. It
gives the best chance of reading an unknown bar code
symbology and also identifies the symbology of each bar
code scanned.
Defaults
Factory
FF3B
This is the default parameter settings that was installed at
the factory. This default set will work for most applications.
Defaults
Registry
FF3C
This restores all parameter settings to the values that
exist in the registry. This is useful for restoring parameters
to a known working set of values which have been saved
using code parameter
FF3F.
Exit and
Restore
FF3D
Stops a label programming sequence and restores all
parameter settings to the values that exist in the registry.
Exit and
Save
FF3E
Stops a label programming sequence. The last valid
parameter settings are left intact.
Exit and
Commit
FF3F
Stops a label programming sequence and writes all
parameter settings into the registry. This can be used to
save a customized set of parameter settings for restoring
later via parameter
FF3C.