Marantz SR5004 User Manual
Page 73
NAMES AND
FUNCTIONS
71
BASIC
CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
ADV
ANCED
OPERA
TION
ENGLISH
8.
When you have fi nished programming the
remote controller, press the SET button,
then LEARN indicator stops blinking and
exits from the LEARN mode.
Notes
• When “NG” is displayed on the LCD once
again, the transmitting code is unavailable for
remote controller, or the transmitting signal is
intercepted by noise.
• If no buttons are pressed for approximately 1
minute while in the LEARN mode, the remote
controller automatically exits from the LEARN
mode.
ERASING PROGRAMMED CODES
(RETURNING TO INITIAL SETTINGS)
Codes can be erased in three ways: by buttons,
sources, and by all memory contents.
ERASING THE CODE BY BUTTONS
1.
Press and hold down the SET and SETUP
buttons until LEARN indicator blinks.
2.
Select
the
SOURCE button to select the
button to be erased.
The source name is displayed on the LCD.
3.
Press and hold down the HDMI button
and press the learned button twice to be
erased.
• “ERASE” is displayed on the LCD and the
mode returns to LEARN mode.
4.
To return the NORMAL mode, press the
SET button.
ERASING THE CODE BY SOURCE
1.
Press and hold down the SET and SETUP
buttons until LEARN indicator blinks.
2.
Press and hold down the HDMI button and
press the learned SOURCE button twice to
be erased.
• “ERASE” is displayed on the LCD.
3.
Press
ENTER button to continue erasing.
• The indicator blinks twice and the
mode returns to LEARN mode.
• To cancel the erasing operation, do not
press ENTER button and simply touch
any other button.
4.
To return the NORMAL mode, press the
SET button.
ERASING THE ALL SOURCES
1.
Press and hold down the SET and SETUP
buttons until LEARN indicator blinks.
2.
Press and hold down the HDMI button and
press POWER ON and POWER OFF button.
• LEARN
indicator
lights.
3.
Press
ENTER button to continue erasing.
• “ERASE” is displayed on the LCD and the
mode returns to LEARN mode.
• To cancel the erasing operation, do not
press ENTER button and simply touch
any other button.
4.
To return the NORMAL mode, press the
SET button.
Note
Erasing codes will return to the factory preset code,
or there will leave empty if the button has no factory
preset code.
ADVANCED OPERATION