Marantz SR5004 - Manual (Page 50)

NAMES AND FUNCTIONS
48
BASIC
CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
ADV
ANCED
OPERA
TION
ENGLISH
ADVANCED OPERATION
2. Adjust the antenna location until signal
strength is good or strong.
3. Select channel 0 (XM000) with the 3 or 4
cursor buttons on the unit or the remote
controller.
3.
3.
• The Radio ID is displayed.
X M O O O : R A D I O I D
Notes
• If “ANTENNA” “TUNER” or “UPGRADE
TUNER” appears in the front panel display, see
Troubleshooting (page 82).
• To change the display content from XM
information to the unit functions, do so with the
DISPLAY button.
SWITCHING XM INFORMATION IN THE
FRONT PANEL DISPLAY
You can display XM information (such as artist name/
song title, category or signal status) for the channel
currently selected in the front panel display.
1.
1.
Press the T.DISP button to displayed
INFORMATION.
Channel number/name
Artist name/Song title
Channel number/name
Channel category
Channel number/name
Surround mode
Satellite signal status
Terrestrial signal status
When the channel number/name is displayed:
X M O 4 6 : T o p T r a
4 6 : T o p T r a c k s
(If text is more than 14 characters long, the text is
scrolled.)
Note
The front Panel display can indicate up to 14
alphanumeric characters at once. If the information
contains more than 14 characters, the information
scrolls from right to left.
When the channel Artist name/Song title is
displayed:
N A M E / T I T L E
D a v i d B o w i e
B o w i e / F a m e
The “NAME/TITLE” is displayed for 2 seconds,
followed by the artist’s name and song title.
(If artist’s name or song title is more than 14
characters long, the text is scrolled.)
Note
The front Panel display can indicate up to 14
alphanumeric characters at once. If the information
contains more than 14 characters, the information
scrolls from right to left.
When the channel category is displayed:
C A T : R o c k
This XM information can also be displayed on a TV
monitor connected to the unit.
2.
3.
4.
1.
1. Press the AMP button on the remote
controller.
2. Press the INFO button. The following
information will be displayed.
V I D E O : D V D
A U D I O : X M
S U R R - M O D E : A U T O
Z O N E A : O N S P K : O F F
Z O N E B : O F F
M A I N V O L U M E
- - - - - - - - - - - - - - - - - - -
3.
When this display appears, press the INFO
button again. XM information like the
following will appear.
X M I N F O R M A T I O N
X M : 0 4 6
C H A N : T o p T r a c k s
C A T : R o c k
N A M E : D a v i d B o w i e
T I T L E : F a m e
S A T : M A R G I N A L
T E R R : N O N
4. P r e s s th e IN F O b u t t o n a g a i n . T h e
information display will go out.
Note
If the information contains a character that cannot
be recognized by that unit, the character will be
displayed with “ ”(space).