Kanguru Mini Clone - Manual (Page 32)

32
5.5 Check
Check mode allows you to run several diagnostic functions that can run status reports on your hard
drives.
There are three Check functions that you can select: Verify, Verify & Repair and Seek Test
5.5.1 Verify
Verify checks all of the sectors on the disk for any bad sectors.
To run a Verify:
1. From the main menu, select Check and then press the ENTER button.
2. From the Check menu, select Verify and then press the ENTER button.
3. Select the location of the hard drive that you want to verify and then press the ENTER button.
4. A confirmation screen appears. Select Yes and then press the ENTER button. The Verify process
begins.
5.5.2 Verify & Repair
Verify & Repair checks all of the sectors on the disk for bad sectors. If there is a sector in which an error
occurrs, dummy data is written into the bad sector to repair it.
Caution! The repair process may change the data on your hard drive. Please make sure you backup any
important data before running the Verify & Repair function.
To run a Verify & Repair:
1. From the main menu, select Check and then press the ENTER button.
2. From the Check menu, select Verify & Repair and then press the ENTER button.
3. Select the location of the hard drive that you want to verify & repair and then press the ENTER
button. The hard drive needs to be connected to either Disk 2 or Disk 4.
4. A confirmation screen appears. Select Yes and then press the ENTER button. The Verify process
begins. If any bad sectors of found they will be automatically repaired.
Check / Verify / Verify & Repair