Kanguru Mini Clone - Manual (Page 13)

13
4. Operating Your Kanguru miniClone
Things to remember
• Make sure that sufficient power is supplied to the Kanguru miniClone. Incorrect power will cause
faulty operation.
• It is OK to connect and disconnect Master or Target drives while the Kanguru miniClone is
powered on. However, do NOT connect or disconnect drives while any function is running or is in
progress.
• Booting an OS using this product is not supported.
• This product may malfunction if it is located close to a radio, television or an audio device. Please
keep the miniClone away from these types of devices during operation.
• This product is for 2.5 inch and 3.5 inch SATA HDD, SATA SSDs, USB / eSATA external hard
drives and flash drives exclusively. The operation of other devices (e.g. optical drives) are not
supported. Bare IDE HDDs are not supported.
• Bare SATA HDDs can be connected to the miniClone without any kind of enclosure. SATA HDDs
are designed to be used with an enclosure. When using this product with SATA HDDs the electrical
components are uncovered. Static electricity may cause damage to electronic devices. Please be
careful and use tools, like electrostatic prevention bands, when handling bare SATA HDDs.
Hardware Setup
1. Place the Kanguru miniClone where there is proper ventilation. Avoid using the Kanguru miniClone
in environments with high temperatures.
2. Before plugging in the AC Power Cable, please make sure that the voltage is adjusted to the same
as your local voltage 110V/220V.
Note: Make sure that sufficient power is supplied to the Kanguru miniClone. Incorrect power will
cause faulty operation.
3. You are now ready to begin using your Kanguru miniClone.
Operating Your Kanguru miniClone