beautypg.com

2 connecting bare hard drives – Kanguru Mini Clone User Manual

Page 10

background image

10

3.2 Connecting Bare Hard Drives

Connecting 3.5” HDDs

Hold the HDD vertically with the SATA connector at the bottom-left and then slowly insert it into the

cradle firmly.

Connecting 2.5” HDDs

Hold the HDD vertically with the SATA connector at the bottom-left and then slowly insert it into the

slot in the cradle firmly.

Warning! When connecting a bare HDD into the Disk 1 or Disk 2 port, please insert the HDD slowly.

Pay attention to the direction that the HDD is facing and the position of the SATA connector. If you insert

the HDD with too much force, it may cause damage to your hard drive or to the miniClone.

Connecting Bare Hard Drives

See also other documents in the category Kanguru Storage: