Ivoclar Vivadent IPS InLine System - Manual (Page 77)

77
Firing parameters
IPS InLine
Veneers
T
°C/°F
B
°C/°F
S
min
t
°C/°F/min
H
min
V
1
°C/°F
V
2
°C/°F
Wash Firing 830/1526 403/757 4 60/108 1 450/842 829/1524
Cervical firing 940/1724 403/757 8 60/108 1 450/842 939/1722
Dentin / Impulse firing 940/1724 403/757 8 60/108 1 450/842 939/1722
Incisal firing 930/1706 403/757 8 60/108 1 450/842 929/1704
Glaze firing 860/1580 403/757 8 60/108 1 450/842 859/1578
T = Firing temperature °C/°F
B = Stand-by temperature °C/°F
S = Closing time in minutes
t ➚ = Heating rate °C/°F/min
H = Holding time
V 1 = Vacuum on temperature °C/°F
V 2 = Vacuum off temperature °C/°F
these firing parameters are guidance values. they are valid for the Programat furnaces from Ivoclar vivadent.
Deviations (approx. +/- 10 °C/18 °F) may occur:
– Depending on the furnace generation.
– If ceramic furnaces from other manufacturers are used.
– In case of regional differences in the power supply or if several electrical devices are operatated on the same circuit.
InLine
®
– Veneer
IPS