Ivoclar Vivadent IPS InLine System - Manual (Page 54)

54
2 nd Opaquer firing
(paste opaquer)
Apply the second opaquer layer in such a way that the metal framework is entirely covered with opaquer. After firing, the
IPS InLine System Opaquer should show a covering, silky-mat shiny surface. After the opaquer firing, the conditioned
surfaces of the alloy framework should be entirely covered with opaquer.
firing parameters IPS InLine System Opaquer (paste opaquer), 1 st and 2 nd Opaquer firing
T
°C/°F
B
°C /°F
S
min
t
°C/°F/min
H
min
V
1
°C/°F
V
2
°C/°F
930/1706 403/ 757 6 100/180 2 450/842 929/1704
tip:
The consistency of the paste opaquer can be individually adjusted using the IPS InLIne System Opaquer Liquid.
Opaquer Firing
Paste opaquer
1 st Opaquer firing (wash firing)
(paste opaquer)
Select the IPS InLine System Opaquer paste in the corresponding tooth shade. If required, homogenize the opaquer paste
by stirring it before taking it from its jar. Extrude the desired amount from the syringe or jar and mix thoroughly on the
mixing pad. Thin it, if required. Apply the first opaquer layer thinly and agitate it into the alloy surface. After firing and
cooling, clean the opaquerized metal framework with the steam jet and dry with oil-free air.
Important
the firing tray with the opaquerized metal framework should only be placed in the firing chamber and
removed from it once the furnace head is completely open and the beeper has sounded.