Ivoclar Vivadent IPS InLine System - Manual (Page 74)

74
T = Firing temperature °C/°F
B = Stand-by temperature °C/°F
S = Closing time in minutes
t ➚ = Heating rate °C/°F/min
H = Holding time
V 1 = Vacuum on temperature °C/°F
V
2
= Vacuum off temperature °C/°F
Firing Parameters
IPS InLine
Conventional metal-ceramic T
°C/°F
B
°C/°F
S
min
t
°C/°F/min
H
min
V
1
°C/°F
V
2
°C/°F
1 st + 2 nd Opaquer firing, powder opaquer 960/1760 403/757 4 100/180 2 450/842 959/1758
1 st + 2 nd Opaquer firing / Gingiva, paste opaquer 930/1706 403/757 6 100/180 2 450/842 929/1704
1 st + 2 nd Margin firing 930/1706 403/757 4 60/108 1 450/842 929/1704
1 st Dentin and Incisal firing / Gingiva 910/1670 403/757 4 60/108 1 450/842 909/1668
2 nd Dentin and Incisal firing / Gingiva 900/1652 403/757 4 60/108 1 450/842 899/1650
Margin Add-On firing 900/1652 403/757 4 60/108 1 450/842 899/1650
Corrective firing after Dentin and Incisal firing, Add-On 860/1580 403/757 4 60/108 1 450/842 859/1578
Shade / Stains firing 850/1562 403/757 6 60/108 1 450/842 849/1560
Glaze firing 850/1562 403/757 6 60/108 2 450/842 849/1560
Add-On after Glaze firing (690 °C/1274) 690/1274 403/757 4 60/108 1 450/842 689/1274
InLine
® – Conventional metal-ceramic
IPS
these firing parameters are guidance values. they are valid for the Programat furnaces from Ivoclar vivadent.
Deviations (approx. +/- 10 °C/18 °F) may occur:
– Depending on the furnace generation.
– If ceramic furnaces from other manufacturers are used.
– In case of regional differences in the power supply or if several electrical devices are operatated on the same circuit.