beautypg.com

Harken 7410.11 MKIV Jib Reefing & Furling User Manual

Page 28

background image

28

MKIV Underdeck Unit 0

Commissioning

Lead Line to Cockpit

Feed the line through bullseye and into spool. Run down into deadend hole located on the lower flange of

the spool and add a stop knot. Tie an overhand or figure-8 knot in the end. Set up lead block so line runs

perpendicular to drum when it leaves bullseye.
The bullseye can correct small differences in line angle. Lead line aft using ball bearing blocks where line

makes a turn more than 30 degrees. Install cleat.

2

1

1. Run line out of hole in bottom of spool

and tie a single overhand knot.
2. Pull knot back up to seat at hole.

Rotate the drum clockwise to charge the spool. Wind 10–15 ft (3–4.5 m) of line on spool.

Deadend Hole

IMPORTANT! Make sure that the suncover, if used, is installed on the starboard side of the sail.