Harken 7410.11 MKIV Jib Reefing & Furling - Manual (Page 13)

MKIV Underdeck Unit 0 13
Preassembly Foil Length Check
Line up bottom foil so foil clamp is just
above or below center of notches in
bottom foil.
Confirm foil length by laying foils alongside
stay with turnbuckle components and torque
tube. Pull stay out straight.
Note: Position top foil so that with top
cap the foil will ride below terminal. If wire
fitting at top of stay is swage, foil must ride
just below shoulder of swage. Mark cut line
on foil. Wrap tape around foil as a guide so
cut is straight.
14" (359 mm)
to underside of deck
If 7301 Halyard Deflector is used, add 1" (25 mm)