Harken 7410.11 MKIV Jib Reefing & Furling - Manual (Page 19)

MKIV Underdeck Unit 0 19
Assembly Foils/Connectors
Use bushings, connector, wedge, and
adhesive in other screw hole and insert
into other foil. Use 1/4 to 1/2 ml. of
adhesive.
Use “ml”
marks to
estimate
adhesive
Stop when you see a small
amount of adhesive enter
one of the screw holes.
Inject only a small amount of adhesive
into middle hole. Unit 0 will only take
1/4 to 1/3 of a graduation mark. Do not
press tip of injector into hole. Back off
slightly while injecting.
Tip: When you see a small
amount of adhesive enter
one of the screw holes,
stop. You have applied
enough adhesive.
Red Loctite ®
Tighten screws into connector holes. Make
sure a drop of red Loctite ® entered each
screw hole. If not, apply to screw.