beautypg.com

Harken 7410.11 MKIV Jib Reefing & Furling User Manual

Page 18

background image

18

MKIV Underdeck Unit 0

Assembly Foils/Connectors

Hold plastic wedge in place with thumb

as you insert into foil. Line foil holes with

connector screw holes.

Loading Injector with Adhesive

Tip: In cooler weather, keep sealed

adhesive in pocket to keep warm. Use

instructions below to fill injector less

than half way; you will only use a small

amount of adhesive. Refill if needed

but do not keep open sealant for long

periods. Use adhesive within 3 hours.
Use cap of adhesive to break seal. Remove

injector tip cap and plunger. Hold injector

at an angle with applicator tip facing down.

Squeeze adhesive into tube so lower half

of injector is full as shown. Keep tip free

of sealant to let air inside.

Adhesive in

lower half

Start plunger into injector and immediately

hold upright so plunger is down and

applicator tip is up.
As sealant runs down towards plunger an

air pocket will form near tip. Push plunger

to evacuate air. You are now ready to begin

injecting adhesive.