Guralp Systems CMG-DM24 - Manual (Page 14)

Operator’s Guide DM-24 Digitiser
Issue G January 2003 12
2.3 QUICK START
1. Connect the GPS cable to the digitiser’s plug marked ‘GPS’ (GPS is not essential
for initial test set-up).
2. The other cable supplied with the module or stand-alone digitiser has one 10 pin
Mil-Spec socket at one end to connect to the digitiser connector marked ‘Data’.
This cable splits into two; one part has a 9 pin ‘D’-type socket to connect to the
COM port of a PC, the other part of the cable is connected to a 11-36V power
supply.
3. Install SCREAM software (see later chapter) on your PC and run.
4. To configure the COM port connected to the digitiser, start from the main window
in SCREAM:-
6. Click on the ‘File’ button , select ‘Setup’
7. Select the ‘Com
Ports’ tab
8. Click on the COM port
to which the Digitiser
is connected.