Gasboy CFN Plus User Manual
Page 59

CFN PLUS Manual
45
Table 3-1. CFN PLUS, Assembly Parts
Item No.
Part Number
Description
Qty
1
800938652 - 800938715
CFN PLUS
1
2
819022200
Wall Mount Kit
1
2a 814423100
Wall
Bracket
4
2b 815122000
Nut
M8
4
2c
815222000
Screw, M8x20, Hexagon Head
4
2d
815322000
Washer, Flat, M8
4
2e
815322100
Washer Spring M8
4
2f
815322400
Washer, Insulator, M8
4
3-6.5. Installation Procedures
Proceed as follows:
Note: If the wall mount is already installed, go to step 4.
1. Open CFN PLUS enclosure
2. Turn CFN PLUS enclosure (1 in Table 3-1) so you face its rear panel (see Figure 3-5)
3. Attach to each support hole in the rear panel a wall bracket (see , 2 in Table 3-1), with nut,
M8x20 screw and flat washer (3/4/5 in Table 3-1). Set the bracket so that they fit to the
proper installation, as shown in Figure 3-6. The wall bracket dimensions are provided in
Figure 3-7.
4. Set the CFN PLUS enclosure (with wall brackets) in the spot and mark the four holes
location from brackets for drilling. Make sure you select place that will allow you to open
completely the CFN PLUS door.
5. Drill four holes in the installation spot (fit for M4 screws)
6. Insert four wall anchors (or equivalent) in the holes
7. Set the CFN PLUS enclosure on the spot so that its installation holes fit with the anchors
8. Insert four M4 screws (6 in Table 3-1) and M4 flat washers (7 in Table 3-1) and secure CFN
PLUS enclosure. Verify that CFN PLUS enclosure is firmly held, and provides a distance
from wall.
9. Take care that all power and communication cables pass through the holes in the bottom
panel