Gasboy Buypass - Manual (Page 34)

Configuration Transaction Pointer
Page 30 MDE-4606B Gasboy CFN Series Buypass Credit and Debit Card Networks · August 2010
Transaction Pointer
If you are not regularly polling and resetting the transaction pointer, you must run the PURGE
SITE command once a day so that you do not fill up the Site Controller’s memory.
Connection to a Hughes VSAT
The Gasboy CFN system can be connected to a Hughes VSAT. You will require the following
to make this connection:
• A C05995 Gasboy 1:1 RS-232 Cable connected to a port on a Hughes Personal Earth
Station (PES). For distances over 8 feet and less than 100 feet, a custom made 1:1 cable
can be installed. Distances over 100 feet require a short haul modem.
• A Hughes PES with one port configured for the Gasboy/Buypass application.
• A special Buynet download from Buypass with two source address numbers in the table
instead of telephone numbers.
Note: For dial backup capability, consult the Hughes representative.
VSAT Installation for Existing Sites
To install VSAT for existing sites, proceed as follows:
1 Print all settings before beginning the installation.
2 Type BUYPASS and verify if the modem baud rate is set to 1200 in the Buypass download
program. Then, type MODEMS and verify if the modem baud rate is also set to 1200 in the
system parameters.
3 Before exiting MODEMS.bin, set the modem type to HAYES ® 1200. Type S to save the
change.
4 Type BUYPASS –FN to disable the modem pre-dial.
5 In SYS_PAR, set the sixth pair of digits in host handler data to 43. Refer to “System
Parameters (SYS_PAR)” on page 10 .
TRY AGAIN KK Re-enter transaction
TRY AGAIN WV Request timed out, try again
TRY AGAIN-PIN 43 Non-numeric PIN
UNAUTH CARD WP Unauthorized card type
USE CREDT KEY 42 Used debit key on reversal of cc
USE DEBIT KEY 4G Used crd key on debit reversal
USE IMPRINTER 41 sohio tran amount $999.99
VEL FILE ERR 9\ System error - velocity file
Message Displayed Description