Gasboy Buypass - Manual (Page 15)

MDE-4606B Gasboy CFN Series Buypass Credit and Debit Card Networks · August 2010 Page 11
Configuring the Site Controller Configuration
Serial Port Configuration - Page 8
Host handler channel The host modem port number. The default port number is none, which is set using
MODEMS.BIN.
Host router data The 13-digit terminal ID received from your Buypass representative.
More router data
Note: This must be blank. The parameter is no longer used for Buypass
configuration.
Send requests to host
handler Set to 24 for credit and checking
Host handler data Two digit numbers. The default numbers are 00 20 00 00. Enter the numbers by
typing the following:
00 Enter 20 Enter 00 Enter 00 Enter 00 Enter Enter
Note: Repeat Enter as required, to exit host handler data.
• The first two digits are maintained by the MODEM.BIN program.
• The second two digit number is a hexadecimal value for the number of seconds
to allow the carrier to be received (this is called Carrier Timeout). The default 20
sets it for 32 seconds. Setting it for 10 would make it 16 seconds, 18 would be
24 seconds, 28 would be 40 seconds, and 30 would be 48 seconds.
Note: Carrier Timeout cannot be set to greater than or equal to the number of
seconds as the Verification Timeout parameter, as on “System
Parameters (SYS_PAR)” on page 10 .
• The third two digit number is not used.
• The fourth two digit number is the carrier synchronization time in tenths of a
second. The range is 03 and 06. Setting it to 00 is the same as 03 (or
three-tenths of a second).
• The fifth two digit number is the time in seconds to wait for ENQ. The range is
01-30. The default is 15 seconds, which is used if the value is set to 00. Some
sites will show improved connectivity if this is set to 3 seconds.
• If setting up a Very Small Aperture Terminal (VSAT), the sixth two digit number
is required. Refer to “Connection to a Hughes VSAT” on page 30 for specific
settings.
• The fifteenth two digit number is maintained by the DEBUG.BIN program (refer
to “Troubleshooting Communications” on page 26 ).
• The sixteenth two digit number is maintained by the DEBUG.BIN program (refer
to “Troubleshooting Communications” on page 26 ).
Transaction Miscellany - Page 11
Bank PIN Data Encryption Standard (DES) YES
Console (CONSOLE)
Information on the content of some of the console parameters that affect network operations
are listed below. Following are the required settings:
Console Parameter Setting
Allow hand entry of card data Yes
Mod 10 check on hand entered non-club cards No
POS asks for odometer on fuel sale 1 (card encoded)
POS asks for auxiliary # on fuel sale 1 (card encoded)
POS asks for odometer on merchandise sale 1 (card encoded)
POS asks for auxiliary # on merchandise sale 1 (card encoded)
The default Buypass configuration also includes parameters for accepting manually-entered
account numbers for Wright Express, Voyager, and Gulf, after the clerk presses the appropriate
network key.