Gasboy Buypass - Manual (Page 20)

Configuration Special System Setup
Page 16 MDE-4606B Gasboy CFN Series Buypass Credit and Debit Card Networks · August 2010
Buypass Initialization
The Buypass router must be initialized when important changes are made, such as changing
the merchant ID.
To initialize Buypass, proceed as follows:
1 Rename the BUYPASS.DLD file by typing the following at the command line:
RENAME BUYPASS.DLD BUYPASS.OLD
2 Reboot the Site Controller by typing REBOOT.
3 When the site turns on, type MODEMS and setup the modem. If the information displayed is
already correct, select 2 and re-enter the number that corresponds with the correct baud rate.
Enter S to save and reboot the site. This will create a new BUYPASS.DLD file.
4 Contact the Buypass customer support and have them set the flag for a table download.
5 Type BUYSTL P to get the download.
Special System Setup
LOAD PRODUCT
Ensure that you have used the uppercase letters R, S, U, D, or F (the first letter of the fuel
descriptions for Regular, Super unleaded, Unleaded, Diesel, and Farm-offroad) to designate
the fuel products with the LOAD PRODUCT command. You must use the letters, for example,
in the names Regular, Supreme, Unleaded, Diesel and Farm-offroad or you could use R1, R2,
and so on.
The symbols are case sensitive and must be the first letter of the word(s) used. Consult your
Buypass representative to name other fuels.
LOAD PHONE
After configuring the Site Controller, use the command LOAD PHONE 3 to load the phone
number supplied by Buypass into the Site Controller. For example, LOAD PHONE 3
19015551212. This phone number will allow you to receive your initial download of
information from Buypass, and you will not use this command again unless something must
happen to this download information. After you have downloaded the Buypass file, check
using BUYPASS-D for the correct number. If there are problems, delete the downloaded
phone number and start again.