Gasboy Buypass - Manual (Page 30)

Configuration Error Messages
Page 26 MDE-4606B Gasboy CFN Series Buypass Credit and Debit Card Networks · August 2010
Troubleshooting Communications
If the site has problems with host communications, the debug program may be used to log the
communications sessions. The debug program has several levels of logging available.
The command is: DEBUG x y
Where x is the output director and y is the level of information to be logged. Typing DEBUG
without any parameters will cause the program to display information about itself, the output,
and the information level.
Output director:
0 = None (no logging)
1 = Most verbose messaging. This is not necessary for most conditions.
2 = Preferred setting for communication (modem) problems.
3 = Preferred setting for most other site problems.
4 = Only pertinent information is logged.
5 = Only critical information is logged. This may not be verbose enough to debug site
problems.
For debugging host communications, the command must look like the following:
DEBUG 2 2
Before starting the logging process, ensure that the router.log file is clear of any obsolete
information. This can be done by typing DEL P:ROUTER.LOG.
After the capture is complete, the debug can be turned off by typing DEBUG 0 0.
Contact Gasboy Technical Service for assistance, or you may print the file to the log printer
using the command:
TYPE;>LOG P:ROUTER.LOG