Gasboy Site Controller II CPU - Manual (Page 8)

Preparing to Upgrade Updating Framos.Cfg
Page 4 MDE-4504 Site Controller II CPU/Memory Board/Program Upgrade Instructions · August 2005
Systems with a Hard Drive and a Floppy Drive
Back up the files on the hard drive by performing a HARDBACK. Refer to Section 13: “How
to Back Up and Restore Hard Disk Files”, in the Site Controller II Manager's Manual (MDE-
4311).
Updating Framos.Cfg
V1.0 to V2.0X or above on an SC II with a Hard Drive
1 Insert the new Release disk in the A: drive, type CP SYSBACK.DTA A: and press ENTER. If
there is not enough disk space remaining on the new Release disk, copy SYSBACK.DTA to
the Applications disk.
2 Insert the new Applications disk in the A: drive, type A:BIN/CONVERT2
C:FRAMOS.CFG A:FRAMOS.CFG, and press ENTER.
3 When prompted, Do you want to save this configuration (Y/N):, insert the new Release disk
in the A: drive, type Y and press ENTER.
V1.0 to V2.0X or above on an SC II with Two Floppy Drives
1 Insert the V1.0 Release disk in the A: drive, and the new Release disk in the B: drive.
2 Type CP SYSBACK.DTA B:, and press ENTER.
3 Insert the new Applications disk in the A: drive, and the V1.0 Release disk in the B: drive.
4 Type A:BIN/CONVERT2 B:FRAMOS.CFG A:FRAMOS.CFG, and press ENTER.
The prompt Insert SCII V1.0 Release disk with current configuration then RETURN:
appears.
5 Press ENTER. The prompt Do you want to save this configuration (Y/N): appears.
6 Insert the new Release disk in the A: drive, remove the disk from the B: drive, type Y, and
press ENTER.
V2.0 to V2.0C or above
Note: If the site has Profit Point(s), before you install the Site Controller upgrade, verify if the
Profit Point version is 2.0 or above. Profit Point versions prior to 2.0 are not supported
in Site Controller versions 2.0C and above. If you need to upgrade the existing Profit
Point(s), see “POS Software Upgrade” on page 16 .