Gasboy Site Controller II CPU - Manual (Page 19)

MDE-4504 Site Controller II CPU/Memory Board/Program Upgrade Instructions · August 2005 Page 15
Installing New Software Upgrading
Procedure C
1 Type FIX CONF and press ENTER.
2 Type REBOOT;A and press ENTER.
3 Type RESTORE EV and press ENTER.
4 Type RESTORE TRANS FR TRANBACK.DTA and press ENTER.
5 Type LO TR XXXX where XXXX is the trans # noted in step 7 of “Taking Backup” on
page 3 .
6 Type RUN;I and press ENTER.
7 If you have been using the Reports Package software, insert the Reports disk made during
HARDBACK into the A: drive, type A:BIN/HARDLOAD, and press ENTER. Once the
reports package has been restored, remove the disk from the A: drive.