Gasboy Site Controller II CPU - Manual (Page 14)

Upgrading Installing a New Memory Board
Page 10 MDE-4504 Site Controller II CPU/Memory Board/Program Upgrade Instructions · August 2005
DSW2 - Baud Rates
Installing a New Memory Board
To install a new memory board, proceed as follows:
1 From the base of the Site Controller, remove the two Phillips screws securing the old memory
board and remove the board.
2 Remove the standoffs from the old memory board, and install them in the same locations on
the new memory board.
3 Ensure that there are no standoffs in the last two mounting holes, on the back of the memory
board.
4 Install C09622 nylon standoff, and C04126 standoff in the rear left mounting hole. Refer to
Figure
3-3 .