Gasboy Site Controller II CPU - Manual (Page 20)

Upgrading POS Software Upgrade
Page 16 MDE-4504 Site Controller II CPU/Memory Board/Program Upgrade Instructions · August 2005
POS Software Upgrade
Note: For more details on this procedure, refer to MDE-4356 - Profit Point Reference
Manual.
1 Before performing an upgrade, back up the data in the POS. You will need 3 formatted
diskettes. If you need to format the diskettes, begin at Step 2. If you already have formatted
diskettes begin at Step 2, but skip Steps 4–8.
2 Press CLEAR MENU and SPECIAL FUNCTION. The Special Function Menu appears.
3 Press 0 Exit to main menu and press ENTER.
4 Press 3 Utility and press ENTER.
5 Press 4 Format a diskette and press ENTER. The Format Diskette Submenu appears.
6 Choose the type of diskette you would like to format. Press 1 for 720K bytes or press 2 for
1.44Mbytes, and press ENTER. The screen prompts you to place the disk in drive A:.
7 After placing the disk in drive A, press ENTER. When the screen prompts you for a volume
label, press ENTER. The display prompts you if you wish to format another diskette.
8 Press Y until all diskettes are formatted, then press N. This returns you to the format diskette
submenu.
9 Press 0 Return to utility menu and press ENTER.
10 Press 0 Return to main menu and press ENTER.
11 Press 6 Backup files to diskette and press ENTER.
12 Press 2 Data and configuration files and press ENTER. The screen prompts you to put a
back-up or blank diskette into drive A: and press any key.
13 Put one of the formatted diskettes in drive A: and press ENTER. The screen prompts you that
this is not a back-up disk and would you like to start a new one?.
14 Press Y. When the back-up process is complete, press any key to return to the Back-up menu.
Ensure that you label the back-up diskettes Data and configuration files with the current date.
15 Press 0 Return to main menu and press ENTER.
16 Press 3 Utility and press ENTER.
17 Press 9 Installation menu and press ENTER. The screen prompts you to place the
Installation disk in drive A:.
18 Place the Installation disk in drive A:, and press ENTER. The screen prompts you to confirm
the date and time.