Important information – Gasboy FiPay Server Retrofit Kit for 8-hose Islander User Manual
Page 11
MDE-5045 FiPay™ Server Retrofit Kit for 8-hose Islander Installation Guide · January 2013
Page 11
Installing the FiPay Server and Additional Hardware Components in the 8-hose Islander PLUS System
9
Secure the spacers using a 9/32-inch nut driver (see
on
10
Carefully insert the short pins of the Printed Circuit Board (PCB) pin header into the CN8
Connector on the back of the 5-port Switch (see
).
Figure 10: Inserting the Short Pins
Short Pins
CN8 Connector
11
Connect the 5-port Switch to the 8-port CN14 slot located on the left side of the board.
12
Ensure that the 5-port mounting holes are aligned with the 8-port board mounting holes (see
Figure 11: Alignment of 5-port Mounting Holes
13
Check the alignment of the 5-port Switch before re-installing the screw. The 5-port
Board must be straight across the top and bottom. The screw hole must be aligned with
the spacer that was installed.
IMPORTANT INFORMATION
Check the position of the 5-port Switch. Ensure that it is parallel to the Islander PLUS cabinet
at the top and mechanical pump cards at the bottom.