Gasboy FiPay Server Retrofit Kit for 8-hose Islander - Manual (Page 10)

Installing the FiPay Server and Additional Hardware Components in the 8-hose Islander PLUS System
Page 10 MDE-5045 FiPay™ Server Retrofit Kit for 8-hose Islander Installation Guide · January 2013
7 Remove the screw on top of the 8-port Commvertor Board using Phillips screwdriver
(see Figure 8 ).
Figure 8: Removing the Screw
Screw
8-port Commvertor Board
Phillips Screwdriver
8 Install the spacer provided in the M09680B032 Kit. The kit includes two spacers for cases
where the on-board spacer is missing. The washer is required only if both spacers are used.
Note: Spacers are NOT required if already installed.
Figure 9: Securing the Spacers
One spacer is already installed.
The second spacer in hand
must be installed.
(i)
(ii)
Spacer
One spacer is already installed. The second spacer must be installed for proper grounding and
proper alignment of the 5-port Switch [see
Figure 9 (ii) ].