Gasboy 8700K - Manual (Page 9)

MDE-4512A Lamp Kit (M06227K00X) Installation Instructions for Atlas® 8700K/9100K and 8800K/9800K · June 2014 Page 9
Installing Lamp Kit (M06227K00X)
4 Using the two Tie-wraps [(Q10178-10) about 8 inches long] per side, secure the strip against
the lamp mounting bracket. Position the tie-wraps about a third of the way from the ends over
the mounting holes in the LED strip as shown in
Figure 4 . Wrap the tie-wrap around the lamp
mounting bracket and LED strip and pull the tie-wraps tight.
Figure 4: Positioning Tie-wraps
(i)
(ii)
Black Tie-wraps (Q10178-10)
Lamp Mounting
Bracket
LED Strip
Black Tie-wrap (Q10178-10)
5 If mounting two LED light strips, repeat steps 3 on page 8 to 4 for the second strip on the
opposite side of the unit.
6 Connect the LED Driver Output Extension Cable [M13980A001 (red and black wires)] to the
red and black wires on the DC OUT end of the LED driver assembly using the two wire nuts.
Ensure to match the wire colors.
7 Connect the other end of the red wire to the closest LED strip J1 connector routing the wire
through the slot in the lamp mounting bracket and over the edge of the LED strip as shown in
Figure 5 on page 10 .