Gasboy 8700K - Manual (Page 7)

MDE-4512A Lamp Kit (M06227K00X) Installation Instructions for Atlas® 8700K/9100K and 8800K/9800K · June 2014 Page 7
Installing Lamp Kit (M06227K00X)
Installing Lamp Kit (M06227K00X)
To install the Lamp Kit, proceed as follows:
Installing LED Driver and LED Light Strips
To install the LED Driver (M13929B001) and LED Light Strips (M13924A001), proceed as
follows:
1 Locate the LED driver, LED Driver Mounting Bracket (M13930A001), and the two Metric
Hexagonal (KEPS) M4 X 0.7 Nuts (Q12885-05) supplied in the kit. Attach the LED driver to
the mounting bracket using the metric hexagonal (KEPS) M4 X 0.7 nuts as shown in
Figure 1 .
Figure 1: Attaching LED Driver to LED Driver Mounting Bracket
DC OUT 
(Red and Black
Wires)
AC IN (Black
and White
Wires)
LED Driver Mounting
Bracket (M13930A001)
LED Driver (M13929B001)
If the kit is being installed into an electronic pump/dispenser (8800K/9800K), locate the LED
driver AC Power Extension Cable (M13928A001) and two Wire Nuts (K81105-02). Matching
the wire colors, attach the cable to AC IN wires (black and white) on the LED driver using the
two wire nuts.
2 Using the two Metric M5 X 8 Screws (M00417B020) from the kit, mount the LED

driver/bracket assembly on the middle of the back of the lamp mounting bar. Position the
assembly so the black and white power wires extend from the right end after the assembly is
mounted.
Note: Figure 2 shows a mechanical register. Mounting of LED driver and the LED light strips
is the same for both mechanical and electronic register units.
Figure 2: Lamp Mounting Bar (Shown with LED Driver/Bracket Assembly Already
Mounted)
(i)
(ii)
Metric M5 X 8 Screw (M00417B020)
Lamp Mounting Bar
LED Driver (M13929B001)