Gasboy 8700K - Manual (Page 10)

Page 10 MDE-4512A Lamp Kit (M06227K00X) Installation Instructions for Atlas® 8700K/9100K and 8800K/9800K · June 2014
Installing Lamp Kit (M06227K00X) Installing Lamp Kit (M06227K00X)
8 Insert the red wire into the V+ input and push the wire into the input firmly until it stops.
Note: If you need to remove the wire, press down on the wire release and pull the wire out.
Figure 5: Inserting Red Wire into V+ Input
Wire Release Slot in Lamp Mounting Bracket LED Strip
J1 Connector
9 Connect the black wire to the back side of LED strip J2 connector, routing the wire through the
slot in the lamp mounting bracket and over the edge of the LED strip. Insert the end of the
black wire into the V- input.
10 Connect the front side LED strip to the back side LED strip using the LED Strip Interconnect
Cable [M13981A001 (blue wire)]. Insert one end of the wire into the V- input of the J2
connector on the front side LED strip, routing it through the slots in the lamp mounting
brackets, and over the edge of the LED strips. Insert the other end into the V+ input of the J1
connector on the back side of the LED strip.
Figure 6: LED Strip Wiring - Two Strips