Before you begin, Preparing for installation, Caution – Gasboy 8700K User Manual
Page 6: Warning
Page 6
MDE-4512A Lamp Kit (M06227K00X) Installation Instructions for Atlas® 8700K/9100K and 8800K/9800K · June 2014
Before You Begin
Before You Begin
Before You Begin
A properly grounded ESD (Electrostatic Discharge) wrist strap must be worn
while servicing any electronic devices or components. Failure to use electrostatic
precautions may damage electronic components and void warranty.
CAUTION
Installing the Lamp Kit (M06227K00X) involves AC wiring to the pump/dispenser.
Before you begin, review and ensure that all wiring and conduit requirements listed in
MDE-4331 Atlas Fuel Systems Installation Manual are followed.
To prepare the site and pump/dispenser for installation, proceed as follows:
1
Ensure that all power has been removed from the unit as listed in
on
.
2
Ensure that the unit is barricaded to prevent customer access as listed in
on
.
3
Match the parts received in the kit with
, for the model pump/dispenser
to be retrofitted.
Failure to turn off the unit during the installation of the kit may cause injury or bodily harm
from electrical shock. Ensure that all power to the unit is switched off before opening the
door to the unit and during installation of the kit.
WARNING
Preparing for Installation
To prepare for the installation, proceed as follows:
1
Unlock and remove the front panel.
2
Remove the two screws located over the tabs of the bezel assembly. Lift the bezel assembly
upward and out to remove.
Note: Save the screws for reassembly of the unit after installation is complete.
If retrofitting an electronic model (8800K or 9800K), loosen and remove the two screws
located on the left and right display panel brackets and pivot the display panels down.
Note: Save the screws for reassembly of the unit after installation is complete.
3
If the kit is replacing an existing fluorescent light kit, carefully remove the existing fluorescent
tubes, ballast, and lamp holders.