Gasboy 9120K Series Installation - Manual (Page 49)

Pulse Rate SW2-1 SW2-2 SW2-3
1 Closed Closed Closed
10 Open Closed Closed
100 Closed Open Closed
250 Open Open Closed
500 Closed Closed Open
None Closed Open Open
None Open Open Open
MDE-4567C 9120K and 9820K Series AST Pumps Installation and Operation Manual · September 2008 Page 45
CPU Switch Settings 9820K Setup and Special Features
Leading zeros are always suppressed in the hundreds and tens positions to the left of the
decimal point. When in standalone mode, positions to the right of the decimal point are
displayed based on the pulse rate selected as shown in the chart below.
Pulse Rate Display
1:1 XXX.
10:1 XXX.X
100:1 XXX.XX
250:1 XXX.XXX
500:1 XXX.XXX
Timeout Switch
When the 9820K is in standalone mode, it will turn off an active hose if it does not detect
pulses for 4 minutes, 15 seconds. This timeout feature can be disabled by setting switch SW2-
4 to Open.
Timeout SW2-4
Enabled Closed
Disabled Open