Gasboy 9120K Series Installation - Manual (Page 34)

Installation Angle Check Valve
Page 30 MDE-4567C 9120K and 9820K Series AST Pumps Installation and Operation Manual · September 2008
Angle Check Valve
Angle check valves must be of a low restriction variety to allow maximum unit flow rate.
Check valves with springs are not recommended.
78” - 83”
198 - 211 cm 9’ / 274 cm 6” / 15 cm 9’ / 274 cm 114” - 119”
290 - 302 cm
12’ / 366 cm 6” / 15 cm 11’ / 335 cm
10’ / 305 cm 2’ 6” / 76 cm 10’ / 305 cm 13’ / 396 cm 2’ 6” / 76 cm 12’ / 366 cm
11’ / 335 cm 4’ 6” / 137 cm 11’ / 335 cm 14’ / 427 cm 4’ 6” / 137 cm 13’ / 396 cm
12’ / 366 cm 6’ 6” / 198 cm 12’ 6” / 381 cm 15’ / 457 cm 7’ / 213 cm 14’ / 427 cm
13’ / 396 cm 8’ / 244 cm 13’ 6” / 411 cm 16’ / 488 cm 9’ / 274 cm 15’ / 457 cm
84” - 89”
213 - 226 cm 10’ / 305 cm 6” / 15 cm 9’ 6” / 290 cm 120” - 125”
305 - 318 cm
13’ / 396 cm 6” / 15 cm 11’ 6” / 351 cm
11’ / 335 cm 3’ 6” / 107 cm 10’ 6” / 320 cm 14’ / 427 cm 2’ 6” / 76 cm 12’ 6” / 381 cm
12’ / 366 cm 5’ 6” / 168 cm 11’ 6” / 351 cm 15’ / 457 cm 4’ 6” / 137 cm 13’ 6” / 411 cm
13’ / 396 cm 7’ / 213 cm 12’ 6” / 381 cm 16’ / 488 cm 7’ / 213 cm 14’ 6” / 442 cm
14’ / 427 cm 8’ 6” / 259 cm 13’ 6” / 411 cm 17’ / 518 cm 9’ / 274 cm 15’ 6” / 472 cm
90” - 95”
229 - 241 cm 11’ / 335 cm 6” / 15 cm 10’ 6” / 320 cm
12’ / 366 cm 4’ 6” / 137 cm 11’ 6” / 351 cm
13’ / 396 cm 6’ 6” / 198 cm 12’ 6” / 381 cm
14’ / 427 cm 8’ / 244 cm 13’ 6” / 411 cm
15’ / 457 cm 9’ 6” / 290 cm 14’ 6” / 442 cm
Legend:
• Height: Measurement from the ground to the hose connection assuming the pumping unit is mounted on top of the tank with the feet
provided.
• Hose Length: Length of hose less nozzles and fittings.
• Register Minimum Radius: Indicates the closest the register assembly can be to the specified starting point; any closer than this distance
may allow hose to touch the ground when unit is not in use. This radius is measured starting from a point directly below pumping unit
discharge to the center of the nozzle boot/hook of the register assembly.
• Fueling Radius: Indicates the approximate fueling radius. Measured from a point directly below pumping unit discharge to the nozzle.
Height
(in/cm)
Hose
Length
(ft/cm) Register Minimum
Radius
(ft/cm)
Fueling Radius
(ft/cm) Height
(in/cm)
Hose
Length
(ft/cm) Register Minimum
Radius
(ft/cm)
Fueling Radius
(ft/cm)