DNF Controls 4000CL-N - Manual (Page 9)

9 4000CL-N, NATIVE Protocol
b. SAVING CLIPS THAT AUTOMATICALLY LOOP
To automatically Loop a clip each time it is loaded, DUPLICATE the clip and assign the
suffix “*” to the CLIP ID.
Press [ENTER] + [0] to add a “*” at the end of the clip name.
c. SAVING CLIPS THAT AUTOMATICALLY PLAY TO
LOOP
1)
To automatically Play to Loop a clip each time it is loaded, DUPLICATE the
clip and assign the suffix “#” to the CLIP ID.
On the ST300: Press [ENTER] + [1] to add a “#” at the end of the clip name.
2)
Set both an IN and OUT Point.
3)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
4)
Press [SHIFT] + [MARK] to initiate the LEARN of the current configuration.
The display shows:
5)
Press VTR [1], VTR [2], VTR [3] or VTR [4] to select the VTRs.
6) Press
[MARK] to LEARN the current configuration, which consists of:
Cue Point, CLIP IDs, IN and OUT Times, Current Directory and Ganged VTRs.
8. RECALL
a.
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE], or by manually
entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b. Press [LOAD].
The ST300 will automatically load the Learned clips on the Learned VTRs, cue the clips
to the Learned time, then set the Learned GANG mode.
Select VTR:
Learn=OK, ESC-Cancel