E. profile connection options, F. drive/directory selection, G. naming conventions – DNF Controls 4000CL-N User Manual
Page 16
16 4000CL-N, NATIVE Protocol
e. PROFILE
CONNECTION
OPTIONS
Open another session and connect an RS-422 cable to another “VTR” label on the back
of the ST300.
From the setup menu on the ST300, assign any ST300 VTR to the new connection (CN).
The ST300 VTR just assigned will be communicating on with the Profile via the new
connector.
The program displays a screen titled “Channels.” Assign a Video, Audio and Timecode
CODECs, Video Input and Video Output as required to Channels 1-4.
If a resource is in use, it will be highlighted in Red.
Click OK when all assignments have been made.
f. DRIVE/DIRECTORY
SELECTION
To change the PROFILE Drive or Directory where Clips will be saved:
1)
Press [MENU] and scroll to the Drive/Directory selection.
2)
Select Drive or Directory by pressing the Softkey
under the menu item.
3)
Scroll to the desired Drive/Directory and press [ENTER].
The selected drive/directory will be used for locating and loading clips.
NOTE: When a Drive/Directory changes, the Clip List created using a different Drive/
Directory is no longer valid. Set all unused VTR Connections and Channels to OFF.
g. NAMING
CONVENTIONS
The ST300 Native Mode Controller can load clips that meet the following requirements:
1)
Clip names cannot exceed 8 characters.
2)
A space cannot be embedded within the Clip Name.
3)
The clip name must be in uppercase characters only.
4)
All special characters can be used.