DNF Controls 4000CL-N - Manual (Page 15)

15 4000CL-N, NATIVE Protocol
c. CONNECTION AND CHANNEL ASSIGNMENTS
1) Press
[MENU] to enter Menu Mode.
2)
Turn wheel until “Press VTR key for CH and CN assignments” is displayed.
3)
Press VTR [1] key. NOTE: VTR [X] toggles between CH and CN assignments.
4)
“VTR 1 Connection” is displayed on the top line.
The bottom line of the display shows “CHA CHB CHC >>> OFF”
5)
Press the keys under these selections to choose a channel.
Select “>>>” to view more channels.
6)
Repeat steps 3-5 for VTRs 2, 3 and 4.
7) Press
[ESC] at any time to exit menu mode.
NOTE: Set all unused VTR Connections and Channels to OFF.
d. COMPLETING THE PROFILE CONNECTION
So far in this setup, the session P1 has been opened on the Profile and is ready for
communication.
Noting the port\session number just selected (P1), locate the P1 connector on the Profile’s
breakout box and connect an RS-422 cable from Port 1 to the connection called “VTR1”
on the back of the ST300.
The default values for channel connections CHA, CHB, CHC and CHD on the ST300 are
for VTR1 (CN1). Upon connection, the ST300 will be communicating with the Profile
on all available channels.
This is the connection just built:
From: To:
Profile Session P1 ST300 ‘VTR1’
On Port 1 Connection 1
VTR
Connection Channel
1 CN1 CHA
2 CN1 CHB
3 CN1 CHC
4 CN1 CHD