DNF Controls 4000CL-N - Manual (Page 8)

8 4000CL-N, NATIVE Protocol
6. LEARN
a. LEARN ON THE ST300
1)
Select a VTR by pressing VTR [1], VTR [2], VTR [3] or VTR [4].
2)
LOAD a Clip (see Section 4).
3)
Repeat steps 1 - 2 until clips are loaded into the desired VTRs and set the
GANG mode, if required.
4)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
5)
Press [SHIFT] + [MARK] to initiate the Learn of the current configuration.
The display shows:
6)
Press VTR [1], VTR [2], VTR [3] or VTR [4] to select the VTR(s).
7)
Press [MARK] to LEARN the current configuration, which consists of:
Cue Point, CLIP IDs, IN and OUT Times, Current Directory and Ganged VTRs.
b. LEARNING IN POINTS, SINGLE CLIP
If the learned clip has an IN point marked, the LEARN time will be the IN point. If there
is no learned IN point, then the current location will be the learned time and will be made
the IN point upon learning.
c. LEARNING IN POINTS, GANGED CLIPS
If the master has no IN point, the current location of each clip in the gang will be learned
as IN points; if the slaves have IN points, the slaved IN points will be overwritten.
7. LOOPING FUNCTIONS
Loop:
Play from the IN point to the OUT point continuously.
Play to Loop: Played from the beginning of clip to the OUT point of the clip, then the clip
plays in a continuous loop from the IN point to the OUT point.
a. LOOP CLIP
1)
Press [LOOP ENABLE] after a clip is loaded to place any clip in loop mode.
To loop clips in GANG mode, the Master Clip should be loaded in loop mode.
All the clips in the Gang will loop when [PLAY] is pressed.
NOTE: Clips will now loop from the IN point to the END of the clip or the
OUT point (if set).
2)
Press [LOOP ENABLE] + [SHIFT] to Play To Loop.
Select VTR:
Learn = OK, ESC-Cancel