Reference, Setup menu – DNF Controls 4000CL-N User Manual
Page 17

17 4000CL-N, NATIVE Protocol
Reference . . .
17. SETUP
MENU
Press [MENU]. The MENU indicator will turn on.
Turn the Wheel to select item to change.
Press [MENU] OR use the Softkeys to change the desired mode for that option.
Turn the Wheel at anytime to select another item.
Press [ESC] at anytime to exit SETUP MENU. The MENU indicator will turn off.
IMPORTANT NOTE:
Please set the following MENU items during initial installation:
ST300 Setup:
Clear Mem; Set Defaults
ST300
Config:
Select
Directory
MENU MODES
(Turning Wheel Clockwise)
DISPLAY
SOFTWARE
VERSION
The version number and date for the currently installed software is displayed.
For example:
RECORD
Press Softkey to select the desired record mode: Lockout, Crash (Full)
CHANNEL,
CONNECTOR
ASSIGNMENT
Press VTR key for CH (channel) and CN (Connector) assignment.
RECORD LOOP
TIME
Enter HH:MM:SS:FF
RECORD
Press Softkey to select single button or 2-button record.
RECORD = [REC] Only OR [REC] + [PLAY]
RECALL MODE
Press Normal or Redirect (Redir).
If [REDIR] is on: The Clip will be REDIRECTED to load on the currently
selected VTR
If [NORMAL] is on: The Clip will be loaded on the VTR it is LEARNED into.
LEARN MODE
In normal mode, you LEARN Current time / IN and OUT points as well as any
gang information.
In CLR_LRN mode, the IN and OUT points are cleared after LEARN is done.
This is used to set multiple Cue Points with individual IN and OUT points in the
SAME video clip.
MARK-Q
Press Softkey to:
Enable ADVANCE to next Cue Point, when [MARK] is pressed.
OR
Maintain CURRENT Cue Point when [MARK] is pressed.
4000CL-N V2.1
072499